AMSOIL PowerSports Air Filters
AMSOIL PowerSports Air Filters for
dirtbikes and ATVs extend equipment life, increase
power and save money. PowerSports Air Filters feature
two layers of oil-wetted polyurethane foam that provide
a superior job at stopping dirt while maximizing air
flow. Their special design improves performance, allows
for better fuel economy and reduces wear.
AMSOIL PowerSports Air Filters
save money. They are washable and reusable for hours
of trouble-free service. In addition, PowerSports
Air Filters have greater life expectancy than competitive
air filters.
PRODUCT DESCRIPTION
AMSOIL PowerSports 2-Stage Air Filters
provide superior performance in all three critical
areas of filtration: Efficiency
(dirt-stopping), Capacity
(dirt-holding) and Resistance
(air flow).
AMSOIL PowerSports 2-Stage Air Filters
are uniquely designed to hold wear-causing dirt while
allowing only clean air for better performance, better
fuel economy, lower exhaust emissions and longer engine
life. Also, AMSOIL PowerSports 2-Stage Air Filters
are washable and reusable for numerous hours of trouble-free
service.
AMSOIL PowerSports 2-Stage Air Filters
are especially designed for PowerSports such as ATV's
and Dirt Bikes. The filters feature two distinct layers
of oil-wetted polyurethane foam, which provides a
network of interlocking cells that trap particles
primarily on the surface, yet allow a constant flow
of clean intake air for outstanding engine protection
and performance.
AMSOIL PowerSports 2-Stage Air Filters
are constructed of polyurethane foam and the 2-stage
foam's thickness allows for even more filtering area
and capacity to trap dirt over a longer period of
time.
POWERSPORTS FILTER CLEANING AND
OILING PROCEDURES
The AMSOIL PowerSports 2 Stage Air
Filter is constructed with the highest quality foam
filter media available. This filter, when used in
combination with AMSOIL Foam Filter Oil (AFO), will
maximize engine performance and provide the most effective
filtration available for your engine.
NOTE: OIL BEFORE USE! AMSOIL PowerSports
2 Stage Air Filters are packaged dry. Proper filter
oiling before use is necessary to prevent dirt from
entering the air intake system. AMSOIL recommends
using AMSOIL Foam Filter Oil (AFO). AFO is properly designed with high quality
tacking agents that stick to dirt. AMSOIL Foam Filter
Oil (AFO) is available
in 8 oz. containers and can be purchased through your
AMSOIL Dealer.
Follow the instructions below to
properly prepare your filter for use.
Your local conditions and intended
use will determine how often your air filter should
be inspected and cleaned. Frequent cleaning and oiling
is necessary for best performance and protection against
engine wear.
Filter cleaning:
1) Carefully remove the air filter
being cautious not to knock any dust or dirt into
the carburetor opening. Clean any dirt from the
opening with a clean shop towel.
2) Clean filter in a solution of
warm water and mild detergent. Do not use strong
solvents, gasoline, or other fuels to clean the
filter.
3) After washing, thoroughly rinse
the filter with clean water and allow it to air
dry. Note: Do not use
high-pressure shop air or heat to dry the filter.
After the filter is completely dry it can be re-oiled
for further use.
Applying filter oil:
For best performance, use a generous
amount of filter oil and work it into foam media.
Squeeze out excess oil, leaving a uniformly oiled
filter.
A properly oiled filter will feel
oily or tacky to the touch on both the outer and
inner surfaces, but should not be dripping filter
oil.
When reinstalling the filter use
a thin film of Multi-Purpose Grease on the foam base
to insure a leak free seal between the filter and
the housing.
|
